Tiler Blacktown's

Tiler Blacktown’s Top Tiling Tips

One of the best tiling tips is to always start in the middle of the wall. To do this, line up a level at about half-way up the wall and then lay a tile on top of it. Pay attention to the corners when you are tiling. Then, follow the same process as with the floor tiles. Once the tiles have been laid, you can move on to the next room and finish the rest.

Plan your tiles in rows. Creating a perfect symmetrical finish requires that you start at the bottom of the room. If the base is uneven, the tiles will amplify this and create uneven grout lines.

To prevent this, use a ledger, a metal angle held in place by wood blocks. A perfectly straight board can also be used as a ledger. Then, start tiling! Once you have laid the tiles on the base, you can move on to the rest of the room.

Remember to level the tile lines before you begin tiling. You can tile over old tiles as long as the joints do not overlap. If the wall paper is still in place, fill it with plaster filler and apply a plaster stabilising solution to it.

Finally, check that the grout lines are even. Using a tile gauge will make your tiling job go much smoother. If you do not know how to use it, ask a professional for help.

You can use a tile gauge to measure the length of the tiles and set them into place. This is an excellent way to ensure that your tiles are even and level. You can even use a nail gun to set them into place.

Another great tip is to mark the tile lines with a marker, which you can then trace using a pencil. It is important to follow the centre line of the floor or wall, as any imperfections in the base will show in your tile.

You should always start from the bottom and work upwards. If you start from the middle, you will avoid uneven areas and uneven grout lines. To do this, you need to use a tile gauge, which is a steel angle that is held in place by wood blocks.

Otherwise, you can use a straight board and place it as a ledger. Then, follow the same steps as above. In the end, you should have a perfect tiled floor.

Before you start laying the tiles, you should measure the length of each tile with a tile gauge. You should always measure the length of each tile before you begin the installation process.

Using a tile gauge will make it easier for you to measure the length of the tiles before you begin your work. In the end, you will have a beautiful tiled floor that will match your taste. Then, you can start tiling the walls and floors of your house.

Information Source: Tiler Blacktown